24Volt DC Power - The BLOCK PowerVision system

The BLOCK PowerVision system 24Volt DC Power is now available with a variety of system components that will suffice all of your 24Volt DC power requirements.

The BLOCK PowerVision 24Volt power supplies are available in semi-stabilised or stabilised versions with each version providing in 10, 20 or 40Amps at 24Volt DC. These environmental technological power supplies will fit into your application.

Additional system components such as UPS, redundant and or selective protection models are the perfect match to your power supply projects.

BLOCK PowerVision PVL and PVSL: equipped to glance into incoming supply voltages. In addition to the series B (PVB and PVSB), BLOCK offers the series L (PVBL and PVSL) with integrated line monitor. Because of the integrated monitor it is possible to glance at incoming supply voltages. This can be to your advantage: An input marked 400 V does not necessarily have to have 400 V available. The series L allows the following data to be read and parametered:

- Current input voltage
- Programmable MIN limit for input voltage
- Programmable MAX limit for input voltage
- Existing input frequency, rotary field

The PowerVision is ideally suited to PLC based control applications, but also setting parameters and communication via laptop is no problem with the new power supply. The software necessary to make PC connections is always ready for down loading from the Internet.

The real power boost of the PowerVision supply can handle up to 200% overload for 4 seconds, or 150% for 8 seconds before the protection system operates.
                    
The top boost in the stabilised PowerVision supply has no problem with peaks of up to 400%.

The center of all PowerVision components is the integrated control module. With this module you can monitor or change all parameter settings. Warning signals protect against malfunction. The integrated display shows all the parameter settings, which can be adjusted to your individual application requirements with just two buttons.

• Display the output settings for voltage and current
• Display and adjust the time functions
• Display and adjust the overload function
• Display the details of power functions (e.g. highest output voltage measured)
• Display the warnings and faults