0-18V, 0-30V, 0-50V, 0-90V, 0-130V, 0-180V, 0-240V, 0-400V,
The HSEUIreg-Series is a programmable switch mode power supply. Engineered and manufactured in by CAMTEC in Germany, it is designed
for challenging applications like railway, drives, test-stands and machine-building. The HSEUIreg provides a low Ripple-Noise, good LoadRegulation
and high efficiency >90% (typ. @ 230Vac). High-end long life capacitors guarantee Hold-up-Time and extended lifetime of the power
supply. Our HSEUIreg-design starts complex loads easily. The internal control manages illegal operating conditions to prevent your system
from failures. An operation failures recording is on board via galvanic insulated relay connection (page 2 table). All HSEUIreg power supplies
are idling-proof and short circuit protected. Supply units of the same type and output voltage feature parallel or series operation.
The HSEUIreg also features active high input transients with suppressor diodes, X2-capacitors and varistors. The design rules set value on
extended interference immunity and safety. The PSU is engineered in accordance to EN60950-1 and EMC-compatibility to EN55022 class B.
The HSEUIreg-series is featured with a thermal overload shut down and
auto recovery behaviour
The power supplies accurately works down low output voltages down to 0V.
Thereby the switching frequency is absolute stabile.
The output response is linear to the input signal.
The HSEUIreg has a sense operation mode to compensate potential drop
at the supply line. It is a standard for the 0...18Vdc, 0...30Vdc and 0...50Vdc
types. For all other types it is a feature up on request..
All HSEUIreg units are featured with a shut down (open collector). ON= open
contact, OFF= closed contact 1Vdc max. . The shutdown connections have
an internal pull-up resistor with 6800 Ω at the plus line (+15V inserted
Output Voltage & output current control:
The output voltage is linear proportional to the input signal.
10% input signal will deliver 10% of the maximum output voltage, 50% input
will give a ratio of 50% output and 100% will provide 100% output. The
USEUIreg features 0-5Vdc, 0-10Vdc, 0-20mA or 4-20mA control signal input.
The setting has to be chosen from a DIP-switch at the front-side. The input
impedance is 1MΩ with voltage control mode settings. The input impedance
is 500Ω with current control mode settings